top of page
In LuxMart we look for suppliers that meet European Electrical and Electronic Product Standards, id est, CEN and CE Marks. However, there are still several defects that may be present in the product that can only be identified through a continuous inspection of the material :
Therefore, we perform Pre-shipment Inspections, Container/Shipping Checkings, Simple Factory Audits (to ensure the reliability of the factory) and Laboratory Testing. The testing of the products includes the following:
LuxMart Quality Testing
 PerformanceRunning Torque Fitting Wide Voltage Range Fatigue Test Power Consumption Stability Assembly |  SafetyHi-Pot Earth Continuity Water Proof Power Cord Strain Relief Polarity Check Abnormal Test Hi-Low Temperature |  LumensLumens value Lumen Efficiency Colour Rendering Colour Temperature |
|---|---|---|
 OthersInternal Check Smell Test Barcode Scanning Carton Drop Test |
If you have any further questions, do not hesitate to contact us.
 AppearanceScratch Dirt Crack Stain Glue Mark Rust on Surface |  FunctionCan't light up Intermittment fuction Unitended fuction Operation noises Flickering Delay in illuminating |  SafetyCircuit Short Wrong Polarity Hi-Pot Test Failure Earth Continuity Problems Sharp Edges Foreign Material in Unit |
|---|---|---|
 SpecificationWrong Colour Temperature Low Colour Rendering Index Low Luminuous Efficiency Low Lumens Incorrect Lamp Base Size |  PackingIncorrect Packaging Wrong Marking Mislabeling Barcode cannot be read Drop Test Failure |  MaterialMold Mark Deformed Part Wrong Material Breakage |
bottom of page